AL.095 No external regenerative resistor error – Delta servo troubleshooting

<= See All alarms of Delta servo

Name Description ALM WRN SRV ON Clear
Way

AL.095

no external regenerative resistor error

As for the 220V 5.5 kW model or above, if the value of P1-53 is not 0 and the external regenerative resistor or the brake is not connected, the alarm occurs.   Yes DI.ARST

Causes Checking Method Actions
The input of regenerative resistor capacity is over 0 and the servo drive does not connect to external regenerative resistor
  1. Check if it is connected to regenerative resistor.
  2. Check if the setting value of P1-53 is 0.
  1. If wishing to apply regenerative brake, please connect to external regenerative resistor. Then, check if the setting of P1-53 is correct.
  2. If not applying to regenerative brake, please set P1-53 to 0.
  3. If the issue persists after conducting the above two steps, please send the drive back to distributors or contact Delta.

(The above information is referenced from Delta Electronics IMSBU)

See ALL Alarms <=        ↓ The following content is contributed by users ↓

Other reasons Checking Method Actions
     

Sharing is a virtue. Please add the inadequacies of this article to benefit the public —

Leave a Reply