AL.303/3E3 CANopen SYNC time-out – Delta servo troubleshooting

<= See All alarms of Delta servo

Name Description ALM WRN SRV ON Clear
Way

AL.303/3E3

SYNC Time-out

The synchronized signal, SYNC of CANopen has not been received in time

3E3

303

303:Yes

3E3:No

NMT: Reset node/

0x6040.Fault Reset

Causes Checking Method Actions
The synchronized signal of CANopen is sent too slow
  1. Check if the communication quality of the circuit is bad.
  2. Check if synchronized cycle 0x1006 is the same as the setting of controller.
  3. Check if the setting of P3-09 is reasonable. (It is better to use the default value)
  4. Check if the order of controller is incorrect

NMT: Reset node or

0x6040.Fault Reset

(The above information is referenced from Delta Electronics IMSBU)

See ALL Alarms <=        ↓ The following content is contributed by users ↓

Other reasons Checking Method Actions
     
     

Sharing is a virtue. Please add the inadequacies of this article to benefit the public —

Leave a Reply