<= See All alarms of Delta servo
Name | Description | ALM | WRN | SRV ON | Clear Way |
---|---|---|---|---|---|
AL.099 DSP Firmware Upgrade |
EEPROM has not been reset after DSP firmware is upgraded. | ⊗ | No | Firstly set P2-08 to 30 ,then set it to 28. And the alarm will be cleared after power cycling. |
Causes | Checking Method | Actions |
---|---|---|
Upgrade DSP firmware | Check if the firmware is upgraded | Firstly set P2-08 to 30. Then set P2-08 to 28, the alarm will be cleared when cycling power on. |
(The above information is referenced from Delta Electronics IMSBU)
See ALL Alarms <= ↓ The following content is contributed by users ↓
Other reasons | Checking Method | Actions |
---|---|---|
After inputting P2-08 = 30,28 AL.017 may be generated when the power is turned on again! (Archer) | Panel display AL.017 | After setting P2-08 = 10, power on again! |
— Sharing is a virtue. Please add the inadequacies of this article to benefit the public —